AER-4001 Marking Fastener Locations for Drilling Project


$11 Enroll

Full course description

Course Description

Before holes are drilled in an assembly, their locations must be marked.

By the end of this course, you will be able to

• Recognize fastener location and identification information on an engineering drawing

• Explain where to find the tools, fasteners, and other supplies needed to create an assembly

• Prepare the surface of an assembly for mark up

• Properly measure and mark corner fastener locations

• Calculate fastener locations using information given on the engineering drawing

• Mark fastener locations using the calculated fastener location information

Estimated completion time (hours): 0.9